Exfo AXS-200/650 IP Triple-Play Test Set Bedienungsanleitung PDF herunterladen (Seite 20)

Connection Setup for IP Triple-Play Verification Tests

14 AXS-200/650

Setup Line Connection

When the AccessMode selection is set

to Routed PPPoE, the available

parameters are the following:

³ Obtain IP is either Dynamic

where the access concentrator or

broadband remote access server

assigns a temporary IP address to

the unit, or Static where you enter

the IP address of the unit.

³ Static IP is the address of the current location assigned by the service

provider. This entry is unavailable if Obtain IP is set to Dynamic.

³ Login Name is your user ID.

³ Password is your user password.

Note: WAN IP setup is not required when Access Mode is set to Bridged. The line

encapsulation setting defines the parameters required.

To select the WAN IP parameters to configure:

1. From the Connection Setup pane, press the left/right function arrows

until the WAN IP tab is displayed.

2. Press the F1, F2, or F3 key located just below the tab to select it.

3. Press the up/down arrows to select the desired parameter.

4. Press to open the list or modify the parameter.

5. In the list, press the up/down arrows to select the function or mode.

Use the alphanumeric keypad to enter the value you want to specify.

6. Press to confirm the selection.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 90 91

Keine Kommentare

Exfo AXS-200/650 IP Triple-Play Test Set Bedienungsanleitung Seite 20