Exfo FPM-600 Power Meter Bedienungsanleitung PDF herunterladen (Seite 28)

Measuring Power or Loss (FPM-600 and FOT-600)

22 FPM/FLS/FOT-600

Defining a List of Favorite Wavelengths

You must put the wavelengths you want to use on a list of favorite

wavelengths (the FAV list). Only wavelengths on this list are available for

measurements. You may enter up to 40 favorite wavelengths.

Specifications are guaranteed for calibrated wavelengths only. For other

wavelengths, the unit will determine values based on the calibrated

wavelengths (3-point interpolation).

To add wavelengths to the FAV list (or to remove them):

1. From normal operating mode, press

repeatedly until you reach PM.

2. Press to access the first submenu, then

press repeatedly until you reach the FAV

menu.

3. Press to switch between available wavelengths. An asterisk (*)

appears beside wavelengths already on the list. If no wavelength is set

for a position, the unit indicates “----”. You may also press to

switch between defined wavelengths only.

Detector

Type

Calibrated

Wavelengths (nm)

Default Favorite

Wavelengths

(nm)

a. To revert to default favorite wavelengths see Reverting Unit to Factory Settings on

page 56.

 Ge 800, 820, 830, 840, 850, 860, 870, 880,

910, 980, 1270, 1280, 1290, 1300,

1310, 1320, 1330, 1340, 1350, 1370,

1390, 1410, 1430, 1450, 1460, 1470,

1480, 1490, 1500, 1510, 1520, 1530,

1540, 1550, 1560, 1570, 1580, 1590,

1600, 1610, 1620, 1630, 1640, 1650.

 GeX All the above plus 1060. Same as above

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 78 79

Keine Kommentare

Exfo FPM-600 Power Meter Bedienungsanleitung Seite 28