Exfo FPM-600 Power Meter Bedienungsanleitung PDF herunterladen (Seite 41)

Using a Light Source (FLS-600 and FOT-600) or VFL

Power Meter/Light Source/Optical Loss Test Set 35

Using Auto-Switching Mode

Note: Auto-switching mode is a special signal detected by compatible units (see

Using Auto-Switching Mode on page 35).

To change the signal modulation:

1. Activate the source.

2. Press to switch between available

modulations.

Using Auto-Switching Mode

In auto-switching mode, your source

automatically switches from one wavelength to

another. When connected to the light source, a

compatible power meter displays the power

value for each wavelength one at a time. The

wavelength value appearing on the display

changes every two seconds.

The unit will show the source's favorite wavelengths one at a time (see

Defining a List of Favorite Wavelengths on page 33).

To activate auto-switching mode:

1. Press to activate the source.

2. Press to switch between available modulations until the Auto

indicator blinks on your display.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 78 79

Keine Kommentare

Exfo FPM-600 Power Meter Bedienungsanleitung Seite 41